WMP FORK CAP SOCKET Category_Electrical K&N Oil Filters are covered

K&N Oil Filters are covered by a limited warranty to be free from defects in materials and workmanship when installed and replaced using engine and equipment manufacturer's recommended service intervals

The Whites Bearing Retainer Tool is designed to remove and install the rear wheel seal/bearing retainer ring while preventing damage to the retainer ring

Flash Point: 78°C

NOTE: This Vertex Top End Gasket Set contains all components pictured

These organic brake pads are a suitable replacement pad for all road bikes and scooters

WMP FORK CAP SOCKET Category_Electrical K&N Oil Filters are coveredThe Whies Fork Cap Socket is used for removal and installation of the fork cap nut (1 3 8" hex) on most big twin and sportster models. Constructed with an o ring insert design that allows you to remove install the fork cap without the risk of damaging the fork cap. An inbuilt 1 2" square socket drive enables the use of a torque wrench for tightening to the manufacturers recommended specification, eliminating the risk of under or over tightening and