The Olsson Block for Ultimaker 2+ / V6 (JET) Colorfabb - Filament low Power AVR 8-bit microcontroller

low Power AVR 8-bit microcontroller 14 Digital I/O Pins (6 PWM outputs) 6 Analoge indgange 32k Flash Memory 16Mhz Clock Speed Tekniske detaljer: Forsyningspænding: 7-12Vdc (5

der er udvalgt med øje for at bringe 3D-printoplevelsen til nye højder

men en temperatur på 60-70°C anbefales for bedre klæbning

•1 lag 35μm (1oz base) kobber

samtidig med at det bevarer en smuk

The Olsson Block for Ultimaker 2+ / V6 (JET) Colorfabb - Filament low Power AVR 8-bit microcontrollerThis is the Custom Heater Block by Mr Anders Olsson, discussed at large in this tread in the Ultimaker forum. Installing it lets you change nozzles on the Ultimaker 2 in less than 20 seconds. This is the Custom Heater Block by Mr Anders Olsson, discussed at large in this tread in the Ultimaker forum. Installing it lets you change nozzles on the Ultimaker 2 in less than 20 seconds. The Olsson Block ships with one JET 0,25JET 0,40JET 0,80 nozzle seen in