Groove Mount Bowden Adapter - 1.75mm Filament steel pla filament Suggested print temperature is 190-230C

Suggested print temperature is 190-230C

The new thermistor placement means you get the most accurate temperature readings with the fastest response

5 steps/mm

and in many cases even better mechanical properties

5A) motor drive circuit

Groove Mount Bowden Adapter - 1.75mm Filament steel pla filament Suggested print temperature is 190-230CThis is a neat little solution for quickly and easily converting a direct extruder that would normally accept a groove mount hotend into a bowden extruder. Simply mounts in like a hotend, but instead accepts our PTFE tubing securely in an embedded bowden coupler. Quite a bit nicer than forcibly screwing a threaded bowden coupler into a printed hole, and allows you to use the existing plethora of excellent direct extruders available in a bowden setup.