Products and systems for the protection and repair of concrete structures. Test methods - Determination of the adhesion of injection products, with or without thermal cycling. Adhesion by tensile bond strength shop-only Manufacturers of tracheal tubes

Manufacturers of tracheal tubes

5 bar(g)) and minimum – 5 kpa (–50 m bar(g))

NOTE 1 Testing is by compliance with these earlier parts

BS 5597 walks through certain tests including pressure test

Both type and sample test procedures are given

Products and systems for the protection and repair of concrete structures. Test methods - Determination of the adhesion of injection products, with or without thermal cycling. Adhesion by tensile bond strength shop-only Manufacturers of tracheal tubes1 Scope This document describes a test method to determine the adhesion to hydraulic concrete of injection products. The test can be applied to polymer and cementetious injection products. The injection may be performed upon cracks in the dry, damp, wet or with water flowing through them. The tensile bond test should always be carried out after the appropriate period of curing under the standard conditions of test detailed below, but may additionally