Ferrite cores. Guidelines on dimensions and the limits of surface irregularities - PQ-cores Ingestion-build-81111 Figure 1 — Example of

Figure 1 — Example of mounting of locating rings (type A)

Manufacturers of pipes and tubes

— the ratio of the cumulative thickness of veneers in alternate directions does not exceed 2

This part of BS EN ISO 14122 gives general requirements for access to stationary machines

Single-number quantity for airborne sound insulation rating is the value

Ferrite cores. Guidelines on dimensions and the limits of surface irregularities - PQ-cores Ingestion-build-81111 Figure 1 — Example of1 Scope This part of IEC 63093 specifies the dimensions that are of importance for mechanical interchangeability for a preferred range of PQ cores and low profile PQI cores made of ferrite, and the locations of their terminal pins on a 2,54 mm printed wiring grid in relation to the base outlines of the cores. It also gives guidance on allowable limits of surface irregularities applicable to PQ cores in accordance with the relevant generic