PrintDry Filament Dryer PRO3 titanium "What will you make

"What will you make

Both versions include a connector pack with the Molex-KK-style housings and crimps to connect the monitor to the Duet board

and chemical resistance of PET matrix

and RV industries and for exterior applications such as mirror housings

CarbonX™ CFR Nylon exhibits improved layer bonding at higher temperatures

PrintDry Filament Dryer PRO3 titanium "What will you makeEasily adjust the temperature with 6 presets (35C, 45C, 55C, 65C, 75C, and 85C). Built in timer with a maximum time of 48 hours. Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent