MDS 80 - Heavy Duty Intermediate car in aluminium - for Seldén mast sections C321 and C365 ø15.8 mm Clevis Pin Diam-INNER: 53 mm

Diam-INNER: 53 mm

Dead-end fitting for a Code Zero halyard

The control sheaves are RBB60 cheek blocks with Torlon ball bearings separated from each other in ball cages

The BBB30 Single Becket Strap Ball Bearing Block is a block suitable for smaller boats or trim lines with dynamic loads

The car is anodized aluminium

MDS 80 - Heavy Duty Intermediate car in aluminium - for Seldén mast sections C321 and C365 ø15.8 mm Clevis Pin Diam-INNER: 53 mmA six wheel, 80 mm long intermediate car in aluminium with shaft for webbing applications. This is the car used between and below the full batten cars. Dimensioned for a righting moment at 30 heel of maximum 550 kNm on a masthead rigged monohull yacht and 450 kNm on a fractional rig. The MDS full batten concept Full support in all directions As the name implies, Seldns MDS (Multi Directional Support) cars are supported in all directions, making sail