Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with polygonal taper interface with flange contact surface Ingestion-build-48183 Whilst some of the recommendations

Whilst some of the recommendations and guidance might also assist in the achievement of other fire safety objectives such as protection of property

as acceptance tests or after repair

Why should you use BS EN 10277- Bright steel products

Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) and verification

Why should you use BS EN 50632‑1 - Electric motor-operated tools – Dust measurement Procedure

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with polygonal taper interface with flange contact surface Ingestion-build-48183 Whilst some of the recommendations1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with polygonal taper interface (PSC) with flange contact surface. The relationship between symbols in this part of ISO 10649 and the ISO 13399 series is given for information in Annex A.