1-1/4" PVC Push Cap Compression Points This pull connector will make

This pull connector will make a secure and strong connection to any 2" rolled Polyethylene conduit for fiber optic - Poly pipe for water lines or -Polyethylene pipe for gas lines  Etc

NOTE: This part is rarely used but in the case of loose gravel or roots pushing back into the hole

comes with 3

(1) Quick shaft

This part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole

1-1/4" PVC Push Cap Compression Points This pull connector will makeThe push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the bell housing on the opposite end of the same pipe, or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling. Once in place, the push cap may be struck with a