3" Drain Cap Compression Points After the Push Point is

After the Push Point is attached to the pipe

This connector is used to connect 1-1/2" poly pipe to the shafts before the shafts are extracted from the ground

Next this pipe/point assembly is shoved into the same opening created earlier by the Bullet Mole

The digging hook can be attached to any digging bar that has a square

This part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole

3" Drain Cap Compression Points After the Push Point isAfter the pipe or conduit is installed over the shafts, this part is used to center the pipe or conduit onto the back end of the shafts. Then as the tool is driven through the ground the 3" drain cap actually pushes the pipe into the hole simultaneously as the Bullet Mole pierces the ground and advances under the pavement.